3K Panel Only (to replace / upgrade existing 3k controller)
If you want complete control over your Kiln, Furnace or Oven these controllers can provide you with multiple temperature ramps, multiple holds / soaks and a delayed start so you can have your kiln fire automatically at a certain time.
They can be programmed to control the whole firing process, including ramp rate, hold times and final temperature, cone and Precious Metal Clay firing are also available.
These are perfect for pottery, glass and PMC and come with some glass type profiles pre programmed in addition to the pottery based cone fire programs.
EG: For the first segment / stage you can set the temperature to rise at 75c / hour to 150c and then hold for 2 hours as a drying stage.
Then for the second stage you can set the temperature to rise at 200c / hour to 900c
Then for the third stage you can set the temperature to rise at 120c / hour to 1100c
Then for the forth stage you can set the temperature to rise at 60c / hour to 1260c and hold for 10 mins.
There are 8 stages and each stage can have a hold added to it, you can modify the ramp / rise rate and the temperature that it goes to on each stage, if you don't need 8 stages you can reduce them in the program setup.
Owning Digital PID ,Bartlett or Nemesis PI Rogue Controller is like hiring an assistant to watch your kiln. Nevertheless, please remember that you should monitor the kiln occasionally during firing, especially near the expected shut-off. (We do not warrant against over-fires.)